Silvagrip® marine nonskid tape has a rockwell hardness of Rc60+ and a high bond strength of 2,500 psi. This alloy is resistant to oils and fuels, unaffected by sun, salt, and weather.
LONGEST LASTING NON-SKID TO HIT THE DECK
Long Lasting
Wear Resistant
Only Silvagrip’s® ceramic abrasives are perma-locked into a sophisticated metal alloy substrate.
Longer Life
Silvagrip's® metal matrix lasts many times longer than traditional resin-based non-skids.
Easy Install
Easy to install peel and stick. No special tools and no waiting – surface is ready to use immediately.
Variety of Colors
From left to right:
-
-
- Black,
- Navy Gray,
- USCG Gray,
- Rust Red (for barges),
- Green (for Helidecks and Offshore Rigs),
- Safety Yellow,
- White,
- Silvagrip® without color.
-
Flexible and durable
When metal decks contract and expand, the adhesive used in Silvagrip® expands and contracts with the metal decking, thus eliminating the potential of cracks, chips and delamination you get with traditional epoxy and grit.
Multiple Styles & Sizes
Silvagrip® is available in various Alloys using combinations of carbides and oxides of Titanium, Tungsten and Ceramics. It is available in both sheets and rolls. It is lightweight and paintable.
Long Lasting
Silvagrip® marine nonskid tape has a rockwell hardness of Rc60+ and a high bond strength of 2,500 psi. This alloy is resistant to oils and fuels, unaffected by sun, salt, and weather.
Side by Side Comparison
Silvagrip® Peel & Stick Nonskid Tape
- Can be applied to any dry clean surface
- Ready for traffic immediately after installation
- No special tools required
- Convenient pre-cut sizes
- Eliminates hot and cold work restrictions
- Uniform surface and clean appearance
- Reduced maintenance and life cycle costs
- Eliminates rust bleed-thru
- No ventilation requirements for installation
- Can be maintained, repaired, or replaced while in port or underway
Traditional Epoxy Non Skid Paint
- Removal is noisy, dirty, and time consuming
- Speciality tools and expereince needed for required surface prep
- Primer must dry and remain clean until epoxy is applied
- Epoxy has a long cure time
- Narrow limits for temperature and humidity
- Areas must be secured for days, preventing other work in the area
- Rework due to someone stepping on the primer or wet nonskid is common
- Temporary ventilation needed for interior applications
- No protection to deck from corrosion – can cause accelerated corrosion
- Significant quantities of hazardous material must be stored
The key advantage of Silvagrip nonskid over epoxy nonskid is that our peel & stick has none of the associated costs and constraints associated with applying traditional epoxy nonskid or removing it.